Tangent Formers, Wingbenders and Endformers – Radius Corners

Tangent Formers
Safes Electrical Enclosure
Boxes & Wireways
Furnace Wrapper Air-Conditioning Cabinets Radius Corners

Tangent Forming Radius Corners on Stainless Steel Oven Cavities

Rollformer with Forming UnitIntegrated Rollform, Tangent Form, and Welding Application  Tangent Form Oven CavityForming Unit with Inline Welding
The System design is to tangent form the two ends and form the 1-1/2” radius corners. The Unit is completely automatic and programmed to produce a variety of three sided “U” Shaped Housings and four sided Full Wrapper Housings.Pre-punched and notched blanks are fed onto an Entry Conveyor which senses the length, width, and punch pattern variables. This information sets the width of the Rollformer and programs the forming sequence of the Tangent Former. The System design is to make a wide range of “U” Shaped and Full Wrapper Housings. Sensing and automatic programming ensures the System produces a good part even when the Operator loads the wrong blank.

A Rollformer makes the front and back outer edge flanges and adjust automatically for the width variable required. Two Tangent Endformers form the 90° lead and trail ends of the Housings. Two Programmed Radius Tangent Forming Units form the 1-1/2” radius corners to produce the “U” Shape or four sided Full Wrapper Housings. Full Wrapper Housings are then held and spot welded inline within the Tangent Forming Unit.

 Stainless Steel Oven Cavity18 Ga. (.042) Stainless Steel
 Tangent Former Oven Cavity Diagram See Video
Click Here

20 GA. Stainless Steel Full Wrapper Housing

See Video
Click Here

Tangent Former Kennel DiagramComplete Coil Fed Notch, Cutoff, and Rollform System with Programmable Tangent Wingformer. The System was designed to produce a wide variety of Stainless Housings with no setup or scrap loss. Daily production can be downloaded from an office computer based on height, width, and quantities required. On Time Production to feed complete Housing directly into the Weld Seam System.  KennelStainless Steel Kennel using a common coil strip width the System is designed to notch, punch, rollform, and tangent form the 1/2” radius corners. The Unit can produce a 48” x 72” Housing the an 18” x 18” without any setup or changeover.

Leave a Comment

Your email address will not be published. Required fields are marked *